Metal oxide-based adsorbents are quite in for wastewater treatment because of their selectivity, stable structure and very low solubility in aqueous systems. To explore the adsorption of methylene blue (MB), Mn 3 O 4 -Bi 2 O 3 adsorbents were made using a wet-impregnation technique with various concentrations of Mn 3 O 4 . The presence of Mn 3 O 4 contents on the surface of monoclinic Bi 2 O 3 was confirmed through representative scanning electron micrographs. The diffractions pertaining to cubic Mn 3 O 4 and monoclinic Bi 2 O 3 were noticed in the XRD pattern of 5% Mn 3 O 4 -Bi 2 O 3 which confirm the composite nature of the adsorbent. XPS analysis revealed the existance of Bi 4f, Bi 4d, Bi 4p, Bi4s, and Mn 2p core levels in Mn 3 O 4 -Bi 2 O 3 . The adsorption study divulged highest efficiency (∼95% and qe = ∼1.4 mgg -1 ) of 5% Mn 3 O 4 -Bi 2 O 3 composite among other contestants in removing 30 ppm MB at 28 ° C, pH 7 and 250 rpm. In addition to the determination of adsorption ability, the effect of preliminary dye concentration (5, 10, 20, and 30 ppm) and contact time (0.5–6 h) on the removal efficiency of prepared adsorbents were also monitored. The adsorption data from the batch experiments were evaluated using the Langmuir, Freundlich, Temkin, and Dubinin-Radushkevich-Kaganer (DRK) adsorption isotherms and pseudo 1 st and 2 nd -order kinetic models. The fitting of adsorption isotherms and kinetic models revealed the formation of adsorbate’s monolayer on the surface of adsorbents through the process of chemisorption. Through FTIR measurement, the MB adsorption onto the effective adsorbent (5% Mn 3 O 4 -Bi 2 O 3 ) was also confirmed. Moreover, TGA analysis showed ∼1.5% weight loss by 5% Mn 3 O 4 -Bi 2 O 3 before MB adsorption whereas ∼2.6% weight loss was noticed after dye adsorption onto the adsorbent. The antifungal activity was evaluated against the fungi A. solani and M. fructicola using the agar well diffusion technique. The 5% Mn 3 O 4 -Bi 2 O 3 composites have exceptional antifungal characteristics compared to Bi 2 O 3 and Mn 3 O 4 , with zone inhibition values of 58.6 and 53.9 mm, respectively.
methylene blue adsorptionmetal oxide adsorbentsdye removaladsorption isotherms
Arabian Journal of Chemistry · مجلد 16 (10) · 105118-105118
Arsenic is a known human carcinogen and its contamination of drinking water has been a global challenge. In this study, magnetic activated carbon (MAC) an efficient adsorbent material with adsorption capabilities of activated carbon and magnetic characteristics of magnetite was synthesized by hydrothermal method. Three adsorbent materials MCH, MCH3 and MCNa were synthesized using different activators like HNO3, H3PO4 and NaOH respectively. Structural and morphological features of the adsorbents before and after magnetization were determined by XRD, FTIR, FESEM, EDX and TGA. BJH nitrogen adsorption-desorption isotherm was used to find the surface area and pore size of adsorbents while the surface charge was determined by measuring zeta potential. FESEM images clearly showed the incorporation of magnetite nanoparticles into a porous network while XRD confirmed the formation of magnetite nanoparticles within the network of porous carbon with average crystallite sizes of 6.3, 5.8, 5.5 nm for MCH, MCH3 and MCNa respectively. To examine the adsorption behaviour of As(III) onto the MAC, batch adsorption experiments were conducted with the effect of different parameters like initial concentration, temperature, time, amount of adsorbent and pH. The results showed that MCNa is a potential adsorbent for As(III) with removal efficiency of 99 %. Overall adsorption process follows pseudo 2nd order kinetics while the Langmuir model was found well applicable to the experimental data. Thermodynamics of adsorption and desorption studies suggest that chemisorption is a predominant adsorption mechanism. Cost-effectiveness, novelty and magnetic recovery are the key features making onion-based MAC a potential adsorbent for the removal of As(III) from contaminated water.
, 25-30 °C), agitation speed (150 rpm). However, both WB and CTAB-mWB derives metal ion removal at lower pH levels (2-4), whereas SDS-mWB requires a pH between 4 and 6 for maximum percentage removal of Cr(vi). The equilibrium data of WB and SDS-mWB were modeled by the Langmuir adsorption isotherm, while the data of CTAB-mWB fitted well in the Freundlich isotherm model. The kinetic analysis of WB, SDS-mWB, and CTAB-mWB revealed that the pseudo-second-order kinetic model provides a thorough explanation for each of these adsorbents. It was found that CTAB-mWB can preferably be used for the removal of chromium(vi) due to its high affinity with adsorbate molecules and adsorption capacity.
In the modern era, problems like eutrophication caused by increased nutrients such as ammonia and phosphorous in freshwater bodies have become the cause of freshwater ecosystem deterioration. To save freshwater by reducing eutrophication, new cost-effective strategies and methods are urgently needed. In this study, titanium oxide nanoparticles dispersed on zeolite were chemically synthesized for the simultaneous removal of phosphate and ammonium ions from aqueous solutions. SEM and XRD analysis were used to characterize the synthesized TiO2/zeolite nanocomposites, which revealed that the synthesized material was more stable and dispersed than zeolite. The nanocomposites removed 38.8% NH4+ and 98.1% PO43− from an initial concentration of both ions of 20 mg 100 ml−1. The removal of both ions was investigated under various conditions including different concentrations of nanocomposites, initial concentration of the solution, temperature, time, and pH. The maximum adsorption of nanocomposites for PO43- was 38.63 mg g−1 at optimal conditions, and 3.75 mg g−1 for NH4+. Kinematics studies showed that both the ions were adsorbed by a pseudo-second-order model. Ion chemisorption occurred as a result of ligand exchange or electrostatic adsorption between ions and nanocomposites. Overall, it was determined that this strategy is a viable and efficient method for simultaneously removing both ions (anionic phosphate and cationic ammonium) from eutrophic waters.